PO Box 2025, Lincoln, CA 95648
How to change the line on models 5620 or 4700
Remove the old line
Get the new line ready
Get the new line ready
To remove the old line, turn the line holders to expose the center loop of line. Push one of the ends towards the head to push the loop up making it easier to grab.
Pull on the loop to remove the line. Do the same for all 3 discs.
Get the new line ready
Get the new line ready
Get the new line ready
The 5620 and 4700 take 3 pieces of line between 10" and 14" long depending on your trimmer's cutting path.
It comes pre-loaded with GrassGator .095 pre-cut Shaped trimmer line.
You can buy our pre-cut line model 5610 or you can cut your own.
Insert the new line
Get the new line ready
Do the same for each disc
Take a new piece of line and fold it in half. Insert one end in each of the small holes on the disc (either side). Keep pushing the line until the ends come out of the other side. Pull the ends of the line to make it tight and even on both sides.
Do the same for each disc
Do the same for each disc
Do the same for each disc
Follow the same instructions for each of the 3 discs.
You are done!
Do the same for each disc
You are done!
You are done!
If the lines fly out of the head, make sure you followed the instructions above. If you stick one line in each hole instead of "weaving" it through the discs, the lines will fly out.